MX Deflection Film Die-Cut Bike Protective 20 piece kit w/ two recycled LDPE squeegees
Glossy, Clear, Oraguard 270 StoneGuard material
6 mil material with 5 year outdoor rated adhesive backing
20 piece die-cut patterns to fit most bikes. We provided more tape than you probably need but everyone's bike and needs are different.
For: Frame, Forks and crank arms.
Clean and dry bike completely. Use Isopropyl alcohol and really wipe it down. Remove wheels to make it easier. Carefully pop out desired piece without peeling off the paper backing. Figure out where to place film and then peel off backing. Apply the center first and slowly work towards the sides, smoothing out bubbles as you go. In tight areas, use a small cut to help film form info area. Use of a pin is also handy if there are any bubbles. Cut to size when needed as well. A hair dryer can really be handy as well.
PINK BIKE REVIEW
The Moto Deflection tape goes on relatively easy—very similar to straight up racer tape. That’s not to say having a blow dryer or heat gun on hand isn’t a good idea. But patient application will see coverage without any annoying bubbles (which can be eliminated with a careful pin prick, same as racer tape). Removal is relatively painless, too (unlike One Manufacturing’s Black Rubber 1/16” thick shuttle guard—that shit is NOT coming off), making re-application a snap should a piece ever need to be replaced.
"Durability wise, the Bicycle Moto Deflection Die Cut Protective Kit is par for the course. Like standard 8 mil racer tape, it resists cutting, rock strikes, and cable rub to keep that frame looking shiny and new vs. chipped or rubbed off paint. It’s outdoor rated, too, and should remain clear for up to five years."
Sizes: 27" x 18" x 6mm Intended use- Large Mountain Bikes