MX Deflection Film Die-Cut Bike/Protective 23-piece kit with Squeegee

MX Film Kit 23-piece Die Cut

Protect your investment by minimizing scratches and dings on your frame and fork. Our MX Film Kit is an easy and affordable way to keep your bike looking good for years! 

Included are 23 pieces of die-cut, impact-resistant, Rock Guard Film. The die-cut design will fit and cover most bikes in critical use areas. Plus, you will have extra pieces for spots you are concerned about.

Specs:

21 Die-Cut pieces for all sizes and kinds of bikes.

Type of film:

Glossy, clear, 5-year outdoor-rated adhesive backing. 

Film Thickness:  .6mm

MX Film is safe for all paint, carbon, steel, and aluminum metals. It is also safe to place on top of stickers.

23 piece die-cut patterns to fit most bikes. We provided more tape than you probably need but everyone's bike and needs are different.

For: frame, forks and crank arms.

Application:

Clean and dry bike completely. Use isopropyl alcohol and really wipe it down. Remove wheels to make it easier. Carefully pop out desired piece without peeling off the paper backing. Figure out where to place film and then peel off backing. Apply the center first, and slowly work towards the sides, smoothing out bubbles as you go. In tight areas, use a small cut to help film form info area. Use of a pin is also handy if there are any bubbles. Cut to size when needed as well. A hair dryer can really be handy as well.

PRO TIP: Get a spray bottle, add a tablespoon of rubbing alcohol to a cup of water. Spray area right before applying film. The moisture helps smooth out the film and it's easier to press-out the bubbles with your fingers before the adhesive makes it more difficult. Start in the center and move the bubbles to the edges of film.

Pink Bike Review

"The Moto Deflection tape goes on relatively easy— very similar to straight up racer tape. That’s not to say, having a blow dryer or heat gun on hand isn’t a good idea. But patient application will see coverage through without any annoying bubbles (which can be eliminated with a careful pin prick, same as racer tape application). Removal is relatively painless, too, (unlike One Mfg's Black Rubber 1/16” thick shuttle guard), that S––t is NOT coming off), making re-application a snap, should a piece ever need to be replaced.

Durability wise, the Bicycle Moto Deflection Die Cut Protective Kit is par for the course. Like standard 8-mil racer tape, it resists cutting, rock strikes, and cable rub, to keep that frame looking shiny and new vs. chipped or rubbed off paint. It’s outdoor-rated too, and should remain clear for up to five years."

Sizes: 24" x 25" x .6mm. Intended use — All Bike