Supreme Ski/Snowboard Tuning Kit
The Supreme Tuning Kit:
We put this kit together along with and the Supremely Hot Tune Kit to be used by skiers and snowboarders alike.
Just about everything you will need to get your equipment ready to go. You need edges that are smooth, sharp, and rust free. And you need some wax on the base to get the most our of your equipment and day.
Includes: 4WD Cool 165g bar. (World Cup proven formula) Large Edger Tool, 8" metal file, gummy Stone, File Brush, 6" scraper, Metal Scraper, White and Black P-Tex sticks, and a high quality, long lasting, custom zippered pouch to keep it all in. (Kit ships in the Blue Stix colorway bag for now)
1. Place Board or skis in a vise to secure and clean base with a fresh hot wax job and scrape or use ONE mfg base cleaner.
2. Check the side and base edges for burrs. Rub a ceramic, diamond or gummy stone over the area to remove burrs in preparation for edge shaping.
3. Use the ONE mfg edge tool to sharpen side edges. Start from the tip and pull smoothly with firm pressure to the tail. Do this in smooth passes until the edges are sharp. Repeat on the other side. Remember to flip the file around so that the teeth face the proper direction...look for the arrow.
4. If you like your board or skis to be catch free in the tip and tail then de-tune using a de-burring stone to round the edges on the tip and tail. Start on the edges as they curve up into the tail and nose and file down approx. 1.5" past the edge contact point as your base lays flat.
When you place the edger on your edge. The number of degrees on the tool which is below the file is the number of the bevel the guild is delivering to your edge.
5. For really sharp edges, take a fine diamond stone or polishing stone and go over the edge again using the same technique.
6. If you like to jib rails and boxes, don't sharpen your edges much to keep them catch free.
7. Clean off base with a dry towel before waxing.
8. Choose your favorite wax for the day. Use and All-Temp if you don't have an idea of what the temperatures will be.
9. Hot wax your base for 10-15 minutes. Do not allow the iron to smoke.
10. When wax is cool scraper with plastic scraper.
11. Brush out base
12. Enjoy the speed!
Keep your edge tool clean with the file brush!
When you place the edger on your edge. The number of degrees, on the tool, which is below the file, is the number of the bevel the guild is delivering to your edge.