The Parking Lot Snowboard / Ski Tuning Kit - Excellent choice for your car and parking lot tune

Excellent choice for your car and parking lot tune!

The Parking Lot Tune Kit is what we carry in our cars to get the job done fast and effectively. The wax, brush, and screwdriver are also pocket friendly for on hill use. Small in size to fit anywhere in your car or bag with the necessary tools and wax for maximum performance. The Parking Lot Tune Kit will work on any board and ski to wax and tune your equipment as good as it can be in the shortest amount of time. Your friends will thank you too!

Includes: F-1 All Temp Rub-On Wax Bar with Cork, Edger Tool, Ceramic Stone, Nylon Brush with Cork Combo Brush, Ratchet Screwdriver with bits. 6" Scraper, Instructions and a Custom Zippered Pouch to keep it all in.

Waxing, Scraping, Tuning Instructions:

Rub-On Wax Instructions:

1. Dry base

2. Warm base if possible (easier to wax)

3. Wear a glove for edge protection

4. Rub Wax into base with pressure. Apply to completely cover.

5. Use cork to polish wax into base.

6. Lightly scrape off (if possible)

7. Lightly brush out or polish to remove extra wax

Hot Waxing Instructions:

1. Select correct temperature specific wax by checking mountain conditions/snow report...(actual snow temperature, not air).

2. Press wax on the iron and distribute small drips of wax over the entire base. DO NOT ALLOW IRON TO SMOKE!

3. With iron in hand, slowly pull the iron over the wax drips smoothing them into a sheet of wax that covers the entire base tip to tail.

4. Let the wax cool 10-15 minutes, then scrape with a sharp plastic scraper. DO NOT USE a steel scraper.

5. Use a wax brush or fiber pad, remove excess wax from base, brushing from tip to the tail. This allows your base to glide fast. 

Tuning Instructions:

1. Place Board or skis in a vise to secure and clean base with a fresh hot wax job and scrape or use ONE MFG Base Cleaner. 

2. Check the side and base edges for burrs. Rub a ceramic, diamond or gummy stone over the area to remove burrs in preparation for edge shaping. 

3. Use the ONE MFG Edge Tool to sharpen side edges. Start from the tip and pull smoothly with firm pressure to the tail. Do this in smooth passes until the edges are sharp. Repeat on the other side. Remember to flip the file around so that the teeth face the proper direction...look for the arrow.

4. If you like your board or skis to be catch-free in the tip and tail then de-tune using a de-burring stone to round the edges on the tip and tail. Start on the edges as they curve up into the tail and nose and file down approx. 1.5" past the edge contact point as your base lays flat. 

5. For really sharp edges, take a fine diamond stone or polishing stone and go over the edge again using the same technique. 

6. If you like to jib rails and boxes, don't sharpen your edges much to keep them catch-free.

Enjoy your speed!