Brush Kit Snowboard / Ski Waxing Brush Kit-Nylon-Horse Hair-Brass

Wax Brush Kit give you the extra speed to finish the hot wax job right! Buying as a set saves money. Custom brush bag keeps them clean and your other gear wax free.

The Wax Brush Kit will get your base dialed in after waxing and up to speed the second your equipment hit the snow. You need edges that are smooth, sharp, and rust free. And you need some wax on the base. The Basic Kit gets the job done.

Includes: Large Nylon, Horse Hair, and Brass Waxing Brushes, F-1 All Temperature High Performance 65g wax, 6" scraper, Instructions and a custom zippered pouch to keep it all in.

Waxing, Scraping, Iron Instructions:

Hot Waxing Instructions:

1. Select correct temperature specific wax by checking mountain conditions/snow report...(actual snow temperature, not air).

2. Press wax on the iron and distribute small drips of wax over the entire base. DO NOT ALLOW IRON TO SMOKE!

3. With iron in hand, slowly pull the iron over the wax drips smoothing them into a sheet of wax that covers the entire base tip to tail.

4. Let the wax cool 10-15 minutes, then scrape with a sharp plastic scraper. DO NOT USE a steel scraper.

5. Use a wax brush or fiber pad, remove excess wax from base, brushing from tip to the tail. This allows your base to glide fast. 

BRUSH TYPE INFORMATION:

Nylon: Use for hard waxes, wax structure, and removing old wax.

Brass: Use to structure waxes and bases. Also used to remove old base material and waxes.

Horse Hair: Use on all wax types for the best polish. Use as the final brush out after a nylon brush.

Tuning Instructions:

1. Place Board or skis in a vise to secure and clean base with a fresh hot wax job and scrape or use ONE MFG Base Cleaner. 

2. Check the side and base edges for burrs. Rub a ceramic, diamond or gummy stone over the area to remove burrs in preparation for edge shaping. 

3. Use the ONE MFG Edge Tool to sharpen side edges. Start from the tip and pull smoothly with firm pressure to the tail. Do this in smooth passes until the edges are sharp. Repeat on the other side. Remember to flip the file around so that the teeth face the proper direction...look for the arrow.

4. If you like your board or skis to be catch-free in the tip and tail then de-tune using a de-burring stone to round the edges on the tip and tail. Start on the edges as they curve up into the tail and nose and file down approx. 1.5" past the edge contact point as your base lays flat. 

5. For really sharp edges, take a fine diamond stone or polishing stone and go over the edge again using the same technique. 

6. If you like to jib rails and boxes, don't sharpen your edges much to keep them catch-free.

Keep your edge tool clean with the file brush! 

Enjoy your speed!